Great firearms, though not something most folks are going to do much with outside of plinking at the range. It will help minimize the rattling you get with the looser slide fit, and help recoil noticeably. I think my hammer spring was 17#, and the guide rod spring was 12#.ĥ. I run reduced power springs in mine, but that's because I run reduced power ammo through mine. It can be done, but it usually takes 2-3 times and copious amounts of profanity to get it right.Ĥ. If you have have to switch the mag release from right to left-handed or vice versa, make sure you do it in a white room with little obstruction, because the spring and parts will fly in all directions a couple of times before you get it right. There are only three parts that need to be smoothed, and it should take any competent gunsmith about 15 minutes to do it.ģ. Taking the gun to a smith and having him smooth the trigger pull will help greatly. After time, it will start to loosen and wobble, and the pin could break.
If it's a two-piece rod, change it out for a solid rod. That is here (if your 92 is Italian made): įrom my years of owning an Elite II (which is very similar to the 92FS), here are some things to know (if you don't already):ġ. So, while changing the hammer spring, may as well replace the Italian roll pin with the USA style lanyard loop (that you can simply push out using a small allen wrench - when the grips are off). If it is an Italian 92, it will have a roll pin that must be knocked out. And, it is still a factory part.Īlso, if it is a USA made 92, it will have the USA style lanyard pin. I have them installed in all nine of my 92s. And, the SA pull should end up around 4.5 pounds. The D spring will take the DA pull from 11.5+ lbs to the 8-8.5lb area. Get the D spring here (Brownells handles all factory parts for Beretta now):